E Playfoot

ALLCHIN 1:8 SCALE

TRACTION ENGINE

This delightful Allchin traction engine was re-built by E Playfoot and shown at Alexandra Palace in 2018. The Allchin in 1:8 scale is probably the most popular model traction engine of all time. The design is by Bill Hughes and was fully described in a book and a magazine serial. It is 60 years since the model was described, the first time that instructions were given on how to build a true-scale live steam working traction engine.

The model was of the last traction engine made by Allchins of Northampton in 1925. It was tentatively given the name Royal Chester as it was intended to show the engine at the Royal Show in Chester. Although she was never fitted with name plates, the name stuck.

No 3251 was a 7hp general purpose engine which Bill Hughes first saw in 1948 while out ‘hunting’ engines on foot and bicycle in North-east Derbyshire. She was in the yard of J.G. and B. Earnshaw, threshing contractors, along with two other Allchins and a Marshall. The Earnshaw brothers allowed him to pay many visits to measure the engine. The other three engines were sold for £25 a piece (what would they be worth today?) but Bill persuaded pioneer preservationist, Chris Lambert, to buy the Allchin engine and it was restored.

Bill’s articles proved highly popular and large numbers of models were built, mostly to the scale of his design, but some others ranging from 15mm/ft to half size. Cherry Hill famously modelled Royal Chester in 1:16 scale as her first traction engine.

Dimensions recorded by Bill Hughes:

Rear Wheels:  6 ft. diameter, 8.5in. wide, two driving-pins.

Front Wheels:  3 ft 10in 9 in. wide 10 spokes.

Flywheel: 4 ft. 6 in. diameter, rim 6 in. wide by 1.75 in. thick, 6 spokes. 

Single Cylinder: 10 in. bore by 12 in. stroke.

Connecting-rod centres: 3 ft. 3 in.

Eccentric-rod centres: 2 ft. 8.5in. Eccentric-sheave diameter: 7 in.

Crankshaft as forged: 4 in. diameter. (All journals turned to 3.5in. diameter.)

Steering-wheel: 17 in. diameter, 5 spokes.

Brake operating wheel: 13 in. diameter, 6 spokes.

Hornplates  0.625 in. thick, and distance between them is 32.5 In. thus firebox is also 32.5 in. wide and boiler ditto diameter, with lagging 1.5in thick.

Bolting flange at chimney foot  13 in. diameter.

Width of engine over hind wheels: 7 ft. 7 in.

Width over tender: 2 ft. 10.5 in.

Thickness of plating of tender: 0.75 in.

Distance between tender side and nearside hind wheel: 13 in.

Distance between tender side and offside hind wheel: 10.5in.

Steering on nearside. Pump in cab, at offside, driven by eccentric between crank and crankshaft bearing.

https://www.sarikhobbies.com/model-engineer-builder/